Wheel Suspension 1x1

From Space Engineers Wiki
Revision as of 03:14, 29 January 2016 by Sapphire (talk | contribs) (changed description)
Jump to: navigation, search


Wheel Suspension 1x1 Icon.png
Large Ship Icon.png
Large Ship / Station
Wheel Suspension 1x1
 
Components
Required

 

 
 
6
 
 
Mass (kg):
0
 
Integrity:
0
 
Build time (seconds):
20
 
Active power consumption (MW):
0.002
 
Power Consumer Group:
Utility
 
Dimensions (W x H x D):
1 x 2 x 1
Wheel Suspension 1x1 Icon.png
Small Ship Icon.png
Small Ship
Wheel Suspension 1x1
 
Components
Required

 

 
 
1
 
 
Mass (kg):
0
 
Integrity:
0
 
Build time (seconds):
10
 
Active power consumption (MW):
0.002
 
Power Consumer Group:
Utility
 
Dimensions (W x H x D):
1 x 2 x 1





Overview

This block forms the basis of the wheel, it is made up of two parts the suspension and an attached Wheel 1x1.

Suspension parameters

Steering Angle How far the wheel can steer in ° degrees.
Steering Speed How fast the wheel steers.
Steer Return Speed How fast the wheel moves back to neutral position after steering.
Power How much force in % percent the wheel will have for propelling the vehicle.
Friction How much friction the wheel will produce in %.
Too much friction can cause the vehicle to flip over in corners,
while low friction can cause slipping.
The latter is usually the safer behavior.
Damping The damper component that will absorb an impact.
Set it low (stiff) for even surfaces and high (soft) for bumpy ground.
Strength The 'spring' component of a damper that will reset the damper after an impact.
Set it high for even surfaces to quickly regain stability
and low for bumpy ground to allow the wheels to keep ground contact
and to reduce the risk of launching the vehicle into the air.
Height Offset Controls the ground clearance by setting the center point the spring will try to hold.
A negative value will result in more ground clearance.
Make sure not to set it to the limits to keep some space for suspension travel in both directions.
Suspension Travel How much the wheel can move upwards and downwards to absorb impacts and keep ground contact.
This will not work properly if the height offset is set to its negative or positive limit!

edit table

Programming

See Also